Home News Content

Maintenance Instructions For The Packaging Machine

Jun 24, 2019

1. Regularly inspect the machine parts once a month to check whether the worm gear, the worm, the bolts on the lubrication block, the bearing and other moving parts are flexible and wearable. The defects should be repaired in time and should not be used barely.

2. The machine should be used in a dry and clean room. It should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.

3. After the machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then installed, ready for the next use.

4. When the drum moves before and after the work, please adjust the M10 screw of the front bearing to the appropriate position. If the gear shaft is swaying, please adjust the M10 screw on the back of the bearing frame to the appropriate position, adjust the clearance so that the bearing does not sound, turn the pulley by hand, and tighten it properly. If it is too tight or too loose, the machine may be damaged. .

5. If the deactivation time is long, the machine must be wiped clean, the smooth surface of the machine is coated with anti-rust oil, and covered with a cloth.